You have no items in your shopping cart.
***SALE - SAVE 10% OFF ALL CABLE DISPLAY KITS***
Cable Display Kits – Our Cable Display Kits make it easier for our customers to decorate & personalise their shopfronts or lobbies. The Cable System which are usually sold separately can now be purchased as a group which includes all required fixtures & fittings needed to construct the hanging system. These full height displays once installed can be adjusted & inter changed to suit the customers or advertising needs as frequently as possible.
The Kit includes the following:
- Acrylic Cable System Pocket or Pockets
- Qty.2 Ceiling to Floor Cable Systems
- Cable Clips
1.Firstly, mount the Ceiling to Floor Cable Systems by screwing both the attached Male fixtures in position using a hand drill (qty.1 into the ceiling & the other into the floor).
2.Once secure thread each associated female fixtures to its accompanied male counterpart (you should have 1 female to every male).
3.Loosen the grub screw on the male ceiling cap & thread through the required amount of cable, until there is tension among the system.
4.Once you are happy with the cable length & tension begin to install the associated cable clips, by again loosening the grub screw on each clip & position on the system. (This step depends on the relevant pocket that was purchase).
5.Once the clips are secure begin to position you acrylic winged pocket & tighten your clip along the wing of the pocket, repeat this step with each clip until your system is secure.
6.Your cable kit should now be in operation.
Cable Kit Breakdown:
- 4 x A4 Kit (#2 Ceiling to Floor Systems, #4 Acrylic Winged Pockets Portrait, #16 Clips)
- 3 x A3 Kit (#2 Ceiling to Floor Systems, #3 Acrylic Winged Pockets Portrait, #12 Clips)
- 2 x A2 Kit (#2 Ceiling to Floor Systems, #2 Acrylic Winged Pockets Portrait, #8 Clips)
- 1 x A1 Kit (#2 Ceiling to Floor Systems, #1 Acrylic Winged Pockets Portrait, #6 Clips)
It is essential to check that the Fixings are Strong enough to take the Weight of the items being displayed. 1.5mm Cable has up to 120kg support rate!
For more Information please check out our Blog Page for Video’s and Graphics for Installation on all Cable Display Systems.
N.B. It is important to check the strength of the top fixing. 365displays are not responsible for any installations that go wrong and the responsibility rests with the individual who installs the Cable Display System.
Each Wall to Wall Cable Display System is Sold Separately and Not as a Set! For More information get in contact with one of our Sales team.